Recent content by red350

Anyone know if there were more than 1 size rear window for the half cabs? Or are there differences between seals? I have a 61 and the new seal I have doesn’t fit. I can put the seal in the cab and the window will pass through it. It’s like the window is too small, but it’s the one that came...

Yeah I didn’t think about the spare tire on the travelall.

Not sure about the travelall but the pickups are too easy to put in a blazer/suburban tank with the in tank pump and sending unit. Had one for probably 5-6 years no issues and no pump noise.

Yes if remember correctly it is 1” square tube, I might do it a little different now because as you tighten the straps under the tank the square tube want to push the top of the tank down, but it’s not a major problem. I’ve now gone to a 31 gallon tank from an early 90’s blazer with the in tank...

Sweet!! Thanks for the reply. I figured it was a fairly early scout with the short serial number. It is a 4x4 with half cab. Original color looks to be a tan or something to that effect. At some point someone has changed doors because they are red and have roll up window.

I’m currently working on a baby scout with a serial number of FC5388. The guy I bought it from thought it was a 63 but looking at the numbers it looks like a 61 to me. Any help would be greatly appreciated.

The new cable did the trick, thank you Bill.

Yes thank you Bill, I saw that you already have a new cable headed my way. I will let you know if that does the trick, if not I will send the cable back to you. Thanks

Thanks for the replies. Yes i have the WiFi turned off. It will initially connect and start to log data but then stops before getting enough data to really see what’s going on. I’m not seeing any errors on the device manager for the USB ports. I can’t totally rule out this pos laptop I’m using...

Ok, I guess I’m the only one to ever have this issue. If I get it figured out I’ll post what I found.

Recently installed HFI on my pickup and its running really good, the only problem I’m having is the ability to log data. I have downloaded the WinALDL on the laptop and the driver also, I can get it to connect with the green 20 in the box and it will begin to log data. But after a few minutes it...

Just keep searching and asking questions there’s a wealth of knowledge on this site.

Oh BTW JJ I borrowed your idea on the front stabilizer bar from a blazer. I actually got the whole front axle and installed it with the IH outers. This gave me better caster angle and better pinion angle than the IH front end and with the stabilizer bar it now drives like a truck instead of a 40...

Yeah really, they put a 16 gallon tank on a truck that might get 10 mpg!! Go figure. Lol. But I don’t know of any aftermarket gauges that will work in the factory location that’s why I went for the interface module. If you just needed to get by for a while you could always mount an aftermarket...

Thanks for the positive comments! It has really worked out good for me so far. The first tank I did was the pre 87 blazer tank it was 25 gallons. The second tank was a 31 gallon from a post 87 blazer. They are the same width and length just a little deeper for the 31 gallon. The only...