|
|
|
#1
01-11-2010, 04:30 PM
|
||||
|
||||
Rear Main seal
Anyone have the part number for this or can you tell me if I should use the 1 lip seal or the 2 lip seal? Any help here would be great.
__________________
Its only metal, it puts a good fight but in the end it loses. Remember that. "Its (scout) four-wheel-drive capabilities are equal to anything this side of full tracks" Tetnus, Build in Progress 
|
|
#2
01-12-2010, 10:24 AM
|
|||
|
|||
|
Re: Rear Main seal
In my experience with the SV8s, the two lip seal is better.
__________________
Doc Stewart "Tough Old Geezer" Charter member: IH Old Hippie Club
|
 |
| Tags |
| number , part , rear |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 304 rear main seal | bbar | General IH Tech | 2 | 04-09-2008 09:52 AM |
| Rear main seal and clutch replacement | westernflyer | General IH Tech | 5 | 06-21-2007 09:42 AM |
| rear main seal | brody800 | General IH Tech | 4 | 04-24-2007 05:09 PM |
| Rear Main Seal | Ken C | General IH Tech | 25 | 01-19-2007 02:33 PM |
| Timken #10 bearing rear axle? | Brandon A. | General IH Tech | 17 | 05-04-2005 07:16 AM |
Linear Mode
