![]() |
![]() |
|
#11
|
||||
|
||||
|
__________________
1972 1110 "Heavy Half" 1977 SSII Work in progress |
|
#12
|
||||
|
||||
|
Good find! You're going to be amazed at how many heads you'll turn and how many thumbs-up you'll get. You'll never win a drag race (against much of anything!) but tuned up right the 258 will get you where you're going just fine. Mine has been very reliable (for a rig that age). I don't know about your year but mine has a one barrel Holley that is pretty anemic but works well. A couple times I went out when the temp was 8 degrees and it started on the first try and then sat there and idled without complaint (though if I left it too long like that it would load up). There are lots of performance options. I like to keep things very original but I'm tempted by the idea of a later 2bbl intake with a Motorcraft carb. I can tell that it wouldn't take a whole lot to wake this engine up a bit. Fuel economy isn't anything to write home about. With a 3spd manual I get a very consistent 13.5mpg. It seems to me that with the right tweaking a rig like this should be able to get up to 15 but at some point you spend more money on the upgrades than you do on the gas.
__________________
1967 Impala 283 1974 '100' 258 |
![]() |
| Tags |
| 1010 , 304 , 4x4 , automatic , brake , column , conversion , custom , disc , disc brake , front , hitch , ifs , manual , panels , patch , radiator , rust , scout , scout ii , suspension , trailer , transmission , truck , wheel |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| '61 to '73 IH 100, 1000, 1010 2wd torsion bar IFS current suspension parts SOURCES | MikeInMobile,AL | Restoration Purists | 7 | 10-08-2012 11:52 AM |
| A/B Travelall questions | TheDon | Triple Diamond Trucks | 4 | 04-17-2009 11:00 PM |
| 1010 suspension questions | Eric VanBuren | Restoration Purists | 9 | 07-22-2006 11:37 PM |
| 73 1010 2wd wagonmaster questions | MikeInMobile,AL | General IH Tech | 29 | 09-17-2003 09:53 PM |