|
|
 |
 |
 |
 |
|
|||||||
| Register | Flash Chat | Photopost | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
|
#11
04-05-2012, 08:34 AM
|
||||
|
||||
Re: 345 freeze plug nitemare
__________________
79 Scout II 345 727 Dana 44's Spools front and rear, Dana 20 And On The 8th Day God Created Asphalt So Yuppies Can Wheel Also. 
|
|
#12
04-05-2012, 09:03 AM
|
|||
|
|||
|
Re: 345 freeze plug nitemare
Seal the edges of casting plugs. Use the brass kind. Your 345 uses 1 5/8" on the sides and 1 3/4" on the ends. You really don't need sealant on the brass plugs but I always use some anyway - cheap insurance against any small imperfection of the block holes.
__________________
Doc Stewart "Tough Old Geezer" Charter member: IH Old Hippie Club
|
|
| Tags |
| 345 , advice , air , broke , clean , compression , cutting , hacksaw , heater , hose , hoses , knock , oil , plug , radiator , rebuild , removal , remove , rubber , scout , top , trailer , turn , water , wheel |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Square plug above freeze plugs. | 72scouttwo | General IH Tech | 5 | 07-03-2011 04:58 PM |
| Freeze plug locations on 345? | bluesman423 | General IH Tech | 3 | 06-07-2010 09:06 AM |
| 1962 Scout Freeze Plug Size | david flores | General IH Tech | 2 | 12-25-2007 05:13 PM |
| problem with a cylinder head freeze plug | 76scoutII | General IH Tech | 5 | 07-06-2005 08:54 AM |
| Spark Plug Problem | Supremebeholder | General IH Tech | 1 | 01-04-2005 04:00 PM |
Linear Mode
