Machine shop with SV engine experience

Discussion in 'Gulf Coast Binders' started by Rollercam, Nov 27, 2019.


  1. Rollercam

    Rollercam Farmall Cub

    Joined:
    Apr 8, 2016
    Messages:
    77
    Likes Received:
    23
    Trophy Points:
    8
    Guys,

    I am located in Texarkana, TX and I am looking for an engine builder/machine shop with experience and/or knowledge dealing with some of the idiosyncrasies of the SV engines. I have a 345 with oil pressure and valvetrain ticking issues and I am afraid I may have cam bearing and oiling problems. However, I am not an expert regarding these engines and this “diagnosis” is strictly based off of what I have read while researching my problem. Anyway, it seems like it may be wise to seek out an engine builder with some IH experience if I want the rebuild done correctly. Does anyone have any recommendations?
     
  2. winchested

    winchested Y-Block King

    Joined:
    Oct 12, 2016
    Messages:
    3,794
    Likes Received:
    1,440
    Trophy Points:
    113
    Location:
    Delhi, ON, Canada
    I did my own cam bearings it isn't too hard if you have patience. Buy a cam bearing install tool through Summit.
     

Share This Page