800 wiper motor

Discussion in 'General IH Tech' started by Terry W, Nov 7, 2014.


  1. Terry W

    Terry W Farmall Cub

    Joined:
    Jan 14, 2006
    Messages:
    102
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Ventura, CA
    Id like to take a look at the wiper motors on my 800. Does anybody have any suggestions for removing the pin from the spline end on the wiper shaft?

    Thanks
     
  2. BuffScout

    BuffScout Farmall Cub

    Joined:
    Jul 25, 2013
    Messages:
    262
    Likes Received:
    24
    Trophy Points:
    18
    Location:
    "Forever West" Wyoming
    Small punch.....tap gently until pin comes out & finish removing with needle nose pliers. If you're going to stay with vacuum wiper motors, there is a rebuild thread on here you can search for that is a great resource.
     
  3. jeff campbell

    jeff campbell Lives in an IH Dealership

    Joined:
    Jan 8, 2003
    Messages:
    14,676
    Likes Received:
    1,184
    Trophy Points:
    113
    Location:
    lima,ohio
    drill bits work great, just cant use them to drill with again, tool box stock for the next time needed ! jeff
     

Share This Page