1+1+1=1 LOW 80

Discussion in 'The Skunkwerks' started by STR8LINE, May 26, 2017.


  1. STR8LINE

    STR8LINE Farmall Cub

    Joined:
    May 17, 2017
    Messages:
    74
    Likes Received:
    29
    Trophy Points:
    18
    Baked on some DP48 today [​IMG][​IMG]


    Sent from my iPhone using Tapatalk
     
  2. STR8LINE

    STR8LINE Farmall Cub

    Joined:
    May 17, 2017
    Messages:
    74
    Likes Received:
    29
    Trophy Points:
    18
    Finished up the hinged pieces with intentions of putting some of it back together for fitment. Really pleased the upgraded stainless hinge rods. [​IMG][​IMG]

    This rear corner is the worst damage on the whole body. My plan is to weld up the holes,
    Cut it out and attempt to straighten it on this planishing hammer that I built. And weld it back in. Emphasis on attempt
    [​IMG][​IMG]


    Sent from my iPhone using Tapatalk
     
    Randall Barringer likes this.
  3. sarookha

    sarookha Farmall Cub

    Joined:
    Dec 18, 2014
    Messages:
    454
    Likes Received:
    42
    Trophy Points:
    28
    Location:
    Alba, Texas
    I love your homemade planishing hammer. Inspiring!
     
  4. STR8LINE

    STR8LINE Farmall Cub

    Joined:
    May 17, 2017
    Messages:
    74
    Likes Received:
    29
    Trophy Points:
    18
    I’m still blasting and getting side tracked with things that are out of order if there is such order in a build? Anyway I have 3 glovebox doors for some reason. All 3 had hinges that were wasted. So I made a little jig and knocked out all three with upgraded stainless hinge with 3/16 hinge rod instead of the factory 1/8”. [​IMG][​IMG][​IMG]


    Sent from my iPhone using Tapatalk
     
  5. STR8LINE

    STR8LINE Farmall Cub

    Joined:
    May 17, 2017
    Messages:
    74
    Likes Received:
    29
    Trophy Points:
    18
    And 3 latches and only 1 good one that I’ll have to get a key for. Anyone ever attempt to take one completely apart? Or tried to repair one?[​IMG][​IMG]


    Sent from my iPhone using Tapatalk
     

Share This Page