Separate names with a comma.
Rotella 15w-40. That little gem takes 10 quarts. Go over to the diesel page and there are answers to the correct oil and fuel filters also.
:thumbs up: Last time I did a flush it I bought 3 quarts but didn't use it all.
I had an offset 44 out of a Waggy for over 12 years. Got tired of looking at it. Junked it about 6 months ago. The matching front went in the...
I'm not into the big pissing matches that go on over what formula is better for my engine this week but I've stuck with the rotella T for many...
Can't tell jack from the pic about the front but I think I counted 14 bolts on the rear, with that said looks like someone shaved the bottom of it...
I remember the injection pump being aluminum so any store or brand name aluminum polish and small polishing ball would work but for $30 if it has...
I cut one and adapted a 90's ford fuel door with the ford cap on my Scout II but I cut it pretty high to keep the vent. The one shown above is...
Looks like your column isn't installed correctly. Loosen the two bolts holding the column under the dash and you should be able to move it to...
I would not put the clutch disc in backwards, if it does work it will chatter your teeth out. I'm guessing your clutch disc isn't adjusted...
Make it the everyday beater. You have to be the only person looking for the 80 grill, Scouts don't have square headlights.
When the price of Broncos and FJ40s are so astronomical that the average Joe can't really afford one what does he turn to? The most similar...
Not completely extinct. Rockauto lists that they still have two of them in stock.
Can't say as I didn't have to go that far into mine. Kick panel, dog legs and main floor were good, but the wedge and cab mount were garbage and I...
Either one was available from the factory, my former traveltops all had the sliders which are just more ventilation down here in the summer,...
I thought SSS sold a full piece front floor cab mount as I also had to cut mine to fit the smaller piece that I bought from another vendor, only...
Not crazy about the look of it, like fiberglass. Makes me itch just seeing it but also hard to justify the cost of ceramic coating.
What year is your Scout? 1980 models came with o rings on the fittings, older models were flared. All the fittings on the hydroboost should be o...
I'm not in your neck of the woods but from what I gather most folks have hang out on fakebook because the traffic here on the BP has dropped off a...
Depends on the year of the axle. Only later model SII axles came without the inner seal, but I'm not sure of the year. The 73 full size rear axle...
