Separate names with a comma.
Not being there I can't answer specifics.
open voltage is different from a load.
You can connect wires to the + and - post of the batt and...
Keep in mind that the system adjusts and learns as you drive in closed loop.
Any time you disconnect the batt or ECM it clears that memory.
Transgo TF-2 kit. (or the make of your choice)
it's a little time consuming to install if you have never done one.
Band adjustment- there are 2...
The system needs tuned for your engine.
Your charging system is low.
Could be the charging system or where you're powering the EFI from.
I don't see any data logs or BLM tables to see where your tune is.
The system does NOT retain pressure when the pump is off.
It has bleed holes in...
We already talked this morning.
remove that triangle.
Install a throttle ball in the TBI arm.
make a simple bracket that will bot to those holes...
You're talking apples and oranges.
The conversion is for HFI not a carb.
There is no adv plate movement because there is no mech or vac adv.
Should be covered in the step by step FAQ.
yes, 3/8 feed, 5/16 return.
I never recommend running rubber the whole way.
Safer and cheaper to run...
It lives again!
You may want to go back and reread the spring write up in the BP knowledge base....
Lynn at scout connection in IA has NOS aircleaners for under $50 last i heard.
You have to call. They're not listed.
Not sure what you're asking.
The 1227747 ECM will run the 700r4 with the correct wiring.
The 16197427 PCM will run the 4l60E and 80E trans.
Nothing will affect the HFI install.
The only wire that connects to the HFI is the same wire you will be using for your ignition 12v.
You have some electrical interference that may be the source of your misfire.
I doubt you reved to 6000rpm as shown.
Your TPS is a little high and...
Covered in the parts required FAQ and several others.
See red below....
What you need to do is have everything in front of you while at the jeep and then call.
Why would you run 1/4" all the way?
Did you ever breath through a straw under water?
Did you ever try to breath through a 50' garden hose?
The return should work.
I would not use the T just to avoid the return.
If you're going to redo everything, just mount a single early 90's...
There's way too many variables to discuss them all.
The best way is to simply use the 6 port switch valve if using 2 tanks.
Both senders connect...