Separate names with a comma.
Me and wife will be there saturday 8 am.
Not on FB anymore so couldn't reply there.
Still have a long way to go
Thanks, yes it's definitely open. I stuck my finger in it, then looked in it with a flashlight. I'll plug it.
Another big headache was the transfer case. A while back Ryan and I spent the better part of a day striping it down rebuilding it and doing the...
One road block I have over come is a oil dip stick. The stock tube will not work with headers. The tube needs to be bent (a little) and a...
One thing I like about the "Anything Scout" front bumper.... it makes a great work bench :hammer:
the hole under the water pipe is open.
on my 304 it was blocked off from the factory, actually it was a different plate all together.
When my rig is complete, I want to do some beach runs.
- Sabine to Roll Over Pass
- Matagorda island
Something else - factory air filter assembly for a 4b carb
My scout had factory A/C which has a plate over the vent cut out on the kick panel. I am not putting the A/C back in, so I want to have a vent...
As the title says...
- dash pad in good condition.
- passenger side vent assembly
- heater valve
- windshield wiper fluid holder & hose, sprayer...
I've been busy.. I'll do a update soon
Hey guys, I ordered the wrong part. i needed a small cut out and ordered a large. the gasket is $22 + S&H if someone needs/wants this large one, a...
the typical... "I'm not ready" and "I hope to make the next one"
sorry guys, I had a short run of wrench work going and life got in the way...
New alternator and starter installed, cant see it because of the shock tower.
new brake booster/master cylinder in...
Steering column was rebuilt. I now have a key :D
first part of the dash is installed
I coated with rubberized undercoating.
I liked it enough that I coated the whole thing. ill put a coat of finish paint before i...
to roll the corner I rounded off the edge of a 2x4. clamped the sheet metal in between two boards and used a soft hammer to slowly work the metal...