Separate names with a comma.
For the TA with factory AC you have a couple options. It takes up a lot of room behind the glove box!
You can go under the dash on the drivers...
Call Scout Connection in IA, they have NOS 4bbl air cleaners.
Last I heard they were $45.
As mentioned, any aircleaner with a 5 1/8 hole will fit...
I was waiting for the blue lights to appear!
I have provided pics of all the different IH engine crankcase ventilation systems in these forums.
If you want to find 2 valve covers with no...
You can convert the original like I did for the Hudson or probably use the mopar electronic slant 6 housing like I did in the alternate...
Have you used that little button at the top of the menu bar?
BP knowledge base....
The location of the reduction will make a difference.
Remember back to when you were a kid.
You could breath thru a 1/4" straw under water.
You should always get light on, blink once then stay on when you first turn the key on.
A simple 12v test light can be used to verify the...
You're still ASSUMING too much.
First, I never just swap parts to trouble shoot.
You do not know if the "new" part is good.
Second, the SES light...
If you don't have spark, you won't have fuel.
There are only 3 parts to spark.
All 3 can be tested.
Pickup- use an ohm meter...
As described in the email.
Pink goes to + and white to -
The square coil has 4 terminals but they connect inside.
Pink to pink and...
Here's a link to additional ignition wiring for carb and injection HEI systems.
Also from the start here thread....
Didn't i just answer this question on email?
Just click the start here thread and then go to the wiring thread.
It's just like i described to you....
I doubt the pump running would be your issue.
I have pumps still going after 20yrs. These are all ext mounted.
Your battery would be dead before...
Covered on pg 5 of the write up.
You may have stopped too soon.
Need to read the entire thread.
Click this link.
Then click the little box on the right that says Start...
Your getting wrapped around the IAC counts and shouldn't.
Go for a drive and come back and let it idle.
IAC counts should be just above 0.
Make sure TPS is the last setting you make.