Separate names with a comma.
Used the fabric they make high end convertible tops from. Very durable, waterproof, and not hot like vinyl.
SII axles work grand. An inch or so wider per side, but I haven’t had any issues with that at all. It probably improves turning radius a wee bit.
Saggy axles are fine as is. Move the perches and mount them.
what do you mean by twisted flanges?
For 20 thou I would simply face the flanges and be done with it. A bent housing wont cause the flanges to have runout.
I had to replace the flywheel on one of my tractors due to worn teeth. Interestingly it only had two wear marks on the flywheel (four cylinder),...
What did you say your address was exactly?
Don’t waste your money. Spend the extra, get the Go-Jack type
Where did the IH block crack? From what you wrote it sounds like an outside coolant jacket crack. There are several methods that can be used to...
Much thanks, I just didnt want to find some odd difference later.
Is there any difference in 5x5.5 and 5x139.7 wheels? Mathematically they are the same, I just want to make sure there isn’t some subtle...
Check yourengine and trannymounts.
Also, FWIW, when I changed my 196 for a 345, it was a fair amount of work, but well worth it! A lot more fun to drive with a V8!
There is a rust ring around the lower hole, or what is supposed to be the lower hole, the bracket looks pretty bent.
It looks like it has been painted, but there is now rust in the intake hole, nor is there rust bleeding from it like there is at the pipe plug on...
But its a terrible gear when you need to buy two new lockers to get it!
Use the 392 and put on bigger tires.
Its a 152, look at the dipstick. Also the Dana 18 t case wasnt offered with a 196, they had changed to a 20 by that time IIRC, so there is another...
Looks like Ill have to post to make sure this 3 year old classified ad never dies.
If you decide to use a bearing you can either buy the smooth kingpin, or modify the existing. There is a write up showing just hand grinding off...