Separate names with a comma.
Valve Lift (Inch):
lntake Opens (before TDC) 21°
Intake Closes (after BDC) 63°
Exhaust Opens (before BDC)...
He is referring to "static timing" which is set with the engine off or at idle by turning the distributor body and watching the timing light to...
Street driven gasoline engines do not run well without vacuum advance on the distributor.
This is why we ask for clear photos of your engine (or...
The carb currently installed on your IH is not the original carb for the vehicle.
Your current carb has a manual choke.
The "box with a rod" is...
Power Brake Booster Exchange,
Located on the internet.
If something has been built, then it can be rebuilt.
Carb base gasket for the Holley 2-venturi carb:
Holley P/N 108-52. Note that the heat shield extends under the accelerator pump and...
OK, that is IH p/n 370920R1 and is available by that number on the internet from numerous sources.
It is a 70 durometer nitrile o-ring. The inside...
Not sure on what a "pivot pin o-ring" is....?????
Are you referring to the shift lever shaft seals ? .... or something else ?
For your manual transmission and transfer case........
Available at Tractor Supply.
Here you go.....I copied and pasted the info from the linked post.
It's so easy, even I can do it.
Airtex-Wells 9G8 ,...
Your engine and engine bay look great. Lots of hard work expended to attain that.
"What difference, after all this time, does it make?" H.R.C.
Jan. 31, 1973.
You will want to break loose the fan retaining bolts prior to loosening the fan belts.
Never use wheel bearing grease in locking hubs,...and do not "pack" the locking hubs with grease of any type.
When servicing locking hubs, I...
Looks like it is a Dana 44 from a vehicle with “full time 4WD” and spring over.
What transfer case do you have?
To replace the disc brake rotors on a Scout II Dana 44 front axle. you have to press out the wheel studs to separate the rotor from the drive hub.