Separate names with a comma.
I think you mean dinner.
Are you on Facebook? We have a North Texas Binder on there. it is listed in the events. It is October 19th. Many of us travel down Friday...
we have our annual meeting the 3rd week of October in Marble Falls, TX. We calm it the Round Up. The 3 large Texas clubs meet for a weekend....
The next meeting is on the Dallas side.
Ozona Grill & Bar - Dallas
4615 Greenville Ave, Dallas, Texas 75206
I have read previous threads about this. The issue I need help with is the cylinder is in the locked position. My understanding is that the...
Can anyone provide me with the part numbers for the dana 27 pinion bearings and races? This is for a 67 scout.
The next meeting will be
Saturday, June 22, 2019 at 8 AM – 11 AM
Sonic Drive-In (201 West Nw Highway, Grapevine, TX)
201 West Nw...
What do you use to log with the LM-1? I have the LC-1 and I could never get it to hook up to the Moates APU 1, and log in Tuner pro. I am sure it...
If you were going to purchase a wideband o2 sensor to tune and engine with, which one would you recommend? Brand and Model.
I have an IH 392 with TBI. 55lb per hr injectors. Fuel pressure is 15 PSI. BPW set to 148. It pulls well down low and cruising. Logging 126, 127,...
Pretty much any reputable transmission shop can rebuild a scout transmission. Is it manual or automatic?
I didnt have D6 grounded properly! Fixed it and all is working correctly. Always appreciate your help with the EFI stuff!
It reads 477 mv and doesn’t change on Tunerpro . What pin is the O2 ground? D6
I am trying to log data on a newly installed TBI system. I am using a Autoprom and Tuner Pro to get data. I have tested the Autoprom on another...
WE are moving the march Meeting to Camerons Hobby Shop. The original place we intended will be covered up with the St Patricks day parade.
February 16 hobby shop club cooks
Feb 22 SRRS
March 16 Original Pancake house- NW HWY Dallas
April 6th off-road expo.
Would it be easier to just increase the injector size?
I used the BPW calculator and it says if I run 15 PSI and bump the BPW to 191.4 it should support 214 HP.
Can you run a 4.3 liter TBI throttle body on a stock 392? If so, do you need to bump up the BPW and PSI? How would I calculate what fuel...