Separate names with a comma.
You want a trans cross member.
Good Post Patrick,
Did the steering box come with the pitman arm on it or did you reuse your old one?
I used a press on mine. But just did one on my car using a long wheel nut and 3/4" nut on the hub to seat the stud using and impact.
These are the studs I used.
I can go back and check my rock auto order. I used these DORMAN 610219 on my 44 front for allum wheels. The shoulder...
How'd they loosen off in the first place? You torquing them to 85-90 ft lbs?
You likely wallowed out the holes in the hub and the rotor.
4wheelparts.com cancelled my order on my 35s aparently when the price dropped like 20 people ordered em right away and of course the Canadian...
Rotate the distributer toward the water neck I think your timing is way off.
Ya forgot to mention mine is a high steer set up with a shorter pitman. But still only 2 turns each way.
Yep there is no valve lash adjustment on an SV scout engine 4 banger or 8 cyl.
The market has changed that much. Check some light line dealers.
Upload to YouTube then post the link here. Easiest way to do it.
2 left and 2 right if you have the steering box centered perfectly which mine seems not to be. I'm at 2 1/4 left and 1 3/4 right. Prob just my...
Never checked honestly. I'll go fire it up and check.
Shoulda checked all that cheaper stuff before you did the steering box.
Lucas also has a zddp break in addative.
Many guys swear that dana 30s/44a need to be fully trussed and gusseted for anything more than 33s.
Dirtlifestyle Nate on YouTube just did a full...
I just did cheap upgrade to a CS144 alternator. 60" of 8ga wire shunt from alt stud to starter stud or shorter if you don't care about it...
You need an upgraded alternator system to likely run electric fans reliably. The 4 core alum rad isn't really needed it's been said a 2 core is...
I just had mine replaced. Seal was 100 or so. And glass/ guaranteed install was $250 CDN. So I'm sure in the US it's cheaper.