Separate names with a comma.
I try to start again on something small and easy, then, hopefully work my way up.
Get the big one from HF. You can also set it in an old tire.
I wonder how much equipment he had to buy. That had to be a lot of equipment.
No the PO had the heads off and redid them and put it back together and it would not run. The truck came from New Mexico and he did not bother to...
I had a 392 with a similar problem. This is what I found. I hope that you have a better outcome.[ATTACH] [ATTACH] [ATTACH]
From Doc Stewart and it answered my question as well. Before you re-mount any IH exhaust manifold, repaired or just used, check the alignment of...
If you do a search on the forum here, it recommends drilling out the mounting holes, on the rear dump manifolds. I assume to allow everything to...
With that problem solved, is it worth opening up the bolt holes on the center dump manifolds, as recommended on this form, for the 74/75...
I have no idea, BUT THEY'RE COOL.
On a side note, the yellow trailer that appears in the first photo, looks like the 'Cub Cadet' delivery trailers, that some of the dealers used to...
Good stuff. Once again, history proves the IH engineers, where ahead of their time.
This is my 1974, 200. I have manual gauges installed as well, temp and OP. The only gauge that works out of the originals is the amp meter.
I've been fighting fuel gauge issues for several years trying to get mine to work. With no success. I found this thread tonight, while trying to...
Have you used the NAPA online parts look-up. I have a 1961 with a BG241 and the NAPA part number is MPE OP6622SB, for the electric gauge. The...
I always carry a 6 inch adjustable wrench, 4 inch slip joint pliers and a pocket knife in my pocket. The only truck that I have a tool box in is...
