Whats your Binder need

[ihscoutmatt]

I think its good to have a list of what you need to do to get your ride on the road so I'll start off

Yellow Scout
Im doing the Mopar ignition upgrade and have this left to do
buy
coil wire
drive shaft u joints
assemble
distributor
install
distributor
GM control module
Ford coil

'66 800
install
points an condensor
ballost resistor
new coil
replace clutch
fix gas gauge

'68 800 v8
rebuild carb
clean gas tanks
replace filler necks
install new wiring harness
figure out whats with the brakes
swap on the other body

well thats my list lets see yours

[hogcityracer]

Ok, I'll just list what I need to get rollin', because my future plans would take a couple of pages!

I need to:
pass. side knuckle milled, drilled, and install it
drag link built and install it
extended brake lines
new U-bolts
shock tabs welded on
shocks
rear driveshaft extended
install shift cable
finish bolting in bulkhead

[70binderPA]

floorboards
fresh new 4150 up top
a t3 flange
finish the exhaust
run oil feed lines/return lines
tires
brakes honed/sanded from sitting
trans flush
signal conversion to led
oil change/extended capacity pan welded from two spare pans
wiring verified that it still works
intercooler
inspection/registration/state legal hooplah
50gal boat tank mounted under the bed (fun awaits me)


and some other misc stuff but this is the majority of the need to do vs want to do

[Scoutingitout]

In my Scout I am into the transmission and transfer case. Took some pictures and my wife showed them to some people and got :eek: I'm surprised it made it down the block and back

[BO185]

Time!!! :D

[sammynomas]

Clutch/pressure plate/throw-out bearing.....or swap transmissions.

[supermerle]

Here goes: Mainly need a shop!

1) Change tubs out (in the process)
2) Rotors and brakes
3) Rebuild springs
4) Carb adjustment
5) Paint, Tires, Etc.
6) Mufflers

PS Does it ever stop? Where's Chip Foose when a person needs him?

:beer: and lots of it!

[ihscoutmatt]

Here goes: Mainly need a shop!

1) Change tubs out (in the process)
2) Rotors and brakes
3) Rebuild springs
4) Carb adjustment
5) Paint, Tires, Etc.
6) Mufflers

PS Does it ever stop? Where's Chip Foose when a person needs him?

:beer: and lots of it!

Yea come on overhaulin a team

since that will never happen I started getting my yellow Scout assembled the other day I gotta get a new little tap now to finish though

[Big D103]

Lots of money

[Fuelsmech]

Mine needs gas. Well, it has gas, just needs to get it from the gas tank to the carb. Dang rust in the gas tank always ruining my day.

[ihscoutmatt]

Mine needs gas. Well, it has gas, just needs to get it from the gas tank to the carb. Dang rust in the gas tank always ruining my day.

Ive had that problem, I went through about 5 inline fuel filters before I broke down and bought the por 15 us standard gas tank sealer and have been trouble free ever since Ive used that stuff in 3 tanks now and will use it in my next 800 build as well